Use
' , Do not use overpressure when using steam as the medium.
' , Drain the liquid inside the heat exchanger before working. Before introducing steam, open the bypass valve of the steam trap and check whether all connecting pipes are smooth and leak-free. Then, slowly open the steam valve. After the entire heat exchanger is preheated evenly, slowly increase the valve opening until steam is ejected from the condensate discharge port, then close the bypass valve.
' , b. When turning off the steam, first slowly reduce the opening of the valve. When the amount of water at the condensed water outlet is very small, close the steam inlet valve, open the trap bypass valve, and drain the residual liquid in the heater.
', For heaters that operate intermittently, the above procedures should be strictly followed every time the heater is started and stopped. If the operation is intermittent in winter, in order to reduce the auxiliary time of starting and stopping, you can use the method of non-stop heating when stopping, that is, when not working, reduce the opening of the steam valve, and the heat provided by the steam should ensure that the temperature of the heater is not lower than . Water is continuously discharged from the drain trap.
' ,
' ,
Xinxiang Weiyuan Chemical New Technology Co., Ltd.
Ding Rongwei
Telephone:
Use of air radiators